When it comes to performing WiFi wonders, no one can deny the fact that Netgear extenders are powerful devices. They can help you connect too many devices to the network at the same time without a signal drop. But, all this can pause if your Netgear extender keeps powering down. To fix that, we have jotted down a few troubleshooting tips in the post. They will work irrespective of the fact that you have done Netgear WiFi extender WN3000RPV3 setup or own another extender model.
Why Does a Netgear Extender Keeps Powering Down?
The range extender will keep powering down or get stuck in a reboot loop if it is not getting sufficient from a power socket. This can happen when the socket is damaged or your locality suffers from power outages. You can connect your extender to another socket and use a UPS to resolve this problem. If that fails to help you out, it is recommended that you power cycle the extender by keeping it turned off for a few moments. Otherwise, learn other reasons as well as solutions to get the issue resolved.
Troubleshooting: Netgear Extender Keeps Powering Down
-
Disconnect a Few Devices
Heavy traffic on the extender’s WiFi network makes thing chaotic sometimes. This is because the extender overworks in that case and the network gets interrupted. Therefore, we recommend you lighten the network by disconnecting some devices from the WiFi network.
-
Relocate the Extender
The poor location of the extender on various occasions can cause it to power down randomly. Thus, you need to relocate the range extender and ensure that it is placed away from the factors that create network interference. We have mentioned some of them below for you:
-
Heavy electrical appliances that use EM waves for working
-
Objects that contain a large amount of water
-
Metal objects
-
Reflexive surfaces
-
Bluetooth devices
-
Update the Firmware
If you know what the function of the firmware is then you might be aware of the fact that it controls the hardware functionalities of the extender too. Therefore, you need to ensure that the firmware of the extender is updated. You can follow these steps to check the same.
-
Open a web browser on a PC that is present on the Netgear extender’s network.
-
After that, visit mywifiext.com and login using the valid administrative details.
-
Go to the Firmware Update window after accessing the Management section.
-
After that, select Check Now.
-
If the wizard notifies you that a new firmware version is available for the extender, you need to walk through the on-screen prompts to get the issue resolved.
-
Check the Extender-Router Gap
There are higher chances that the signals emitted by your extender are clashing with those of the router. This case happens when the extender-router gap is very less. Therefore, you are suggested to place the devices at a judicious gap. The gap between them must be more than 5 ft and less than 10 ft. This distance can vary depending upon the physical obstructions present between their paths of communication.
The Concluding Thought
Your extender will keep powering down due to a number of reasons. We have tried to cover all of them in this post. Additionally, we also gave troubleshooting techniques to be followed in order to fix the problem. We believe that after giving a shot at the given tips, things will get better for you. But, if the Netgear extender still keeps powering down, the configuration error might be causing this problem. Therefore, you have to perform a Netgear WiFi extender reset either through the local interface or with the help of the Reset button. But, do not forget to install the extender again as soon as it resets.
